WRT610N / EKO 12412 goes into reboot loop (serial log included)

[owagner]

After updating a 12360 WRT610N to 12412, the device will go into a neverending reboot loop. A serial log of the boot process is available here:

​http://pastebin.com/m37f4459e

I think a similiar issue happened with the pulled test version (12367)

[owagner]

I can reproduce this:

• Debricked using serial console (absolutely no luck using TFTP)
• Flashed 12307, worked fine.
• Flashed 12412, bricked again (insofar as DD-WRT will just reboot during startup)

[davel]

mine loaded without issue, tried both

dd-wrt.v24-12424_std-nokaid_usb_wrt610n.bin dd-wrt.v24-12424_mega-wrt610n.bin

I know YMMV... uptime clock is running

[owagner]

The device in question has:

bootnv_ver=6, pmon_ver=CFE 4.175.64.12

[davel]

Replying to owagner:

The device in question has:

bootnv_ver=6, pmon_ver=CFE 4.175.64.12

My nvram reports bootnv_ver=7, pmon_ver=CFE 4.175.64.16

It did later lock up and and during restart ;

enable WRT610N phy reset hack

Unable to handle kernel paging request at virtual address 0000ff10, epc == 801b3614, ra == 801b35a0

Oops in fault.c::do_page_fault, line 206:

Had to catch it at boot and erase nvram. I failed to do a 3x30 reset.. lets see how it does factory config.

[Eko]

Seems fixed with r12427