Opened 4 years ago
Closed 4 years ago
#1203 closed (fixed)
Unable to set channel in bs 12615 on RS with both R52 and SR2
| Reported by: | anthonymo | Owned by: | somebody |
|---|---|---|---|
| Keywords: | Cc: |
Description
When I change the channel from auto to a set number (chan 1 and 6) it goes to channels 4 and 9 respectivly.... I think its still on auto because after I change the channel and it restarts the network net stumbler shows multiple channels for each SSID before it settles on one
Attachments (3)
Change History (8)
Changed 4 years ago by anthonymo
Changed 4 years ago by anthonymo
comment:1 Changed 4 years ago by anthonymo
Changed 4 years ago by anthonymo
comment:2 Changed 4 years ago by anthonymo
updated to 12638... TX errors resolved but RX errors remain. Also channel and rate stay on auto despite manual setting
comment:3 Changed 4 years ago by anthonymo
Turning off Noise Immunity allows me to set the channel I desire. Is that the correct behavior? The rate is still stuck on auto.
comment:4 Changed 4 years ago by anthonymo
I spoke too soon its still not consistant
comment:5 Changed 4 years ago by BrainSlayer
- Resolution set to fixed
- Status changed from new to closed
this has been resolved. the RS build (and only the RS build) had a bad typo in the wireless driver. i found this last night and tested it on my own private RS. i hope i can upload a new version today
added screen shots, also notice the rate is set to 54 yet the status shows auto