Ticket #1149 (closed defect: fixed)

Opened 5 months ago

Last modified 5 months ago

WRT610N / EKO 12412 goes into reboot loop (serial log included)

Reported by: owagner Assigned to: EKO
Priority: major Milestone:
Component: component1 Version:
Keywords: WRT610N Cc:

Description

After updating a 12360 WRT610N to 12412, the device will go into a neverending reboot loop. A serial log of the boot process is available here:

http://pastebin.com/m37f4459e

I think a similiar issue happened with the pulled test version (12367)

Change History

06/30/09 23:46:51 changed by owagner

I can reproduce this:

- Debricked using serial console (absolutely no luck using TFTP) - Flashed 12307, worked fine. - Flashed 12412, bricked again (insofar as DD-WRT will just reboot during startup)

07/01/09 02:02:39 changed by davel

mine loaded without issue, tried both

dd-wrt.v24-12424_std-nokaid_usb_wrt610n.bin dd-wrt.v24-12424_mega-wrt610n.bin

I know YMMV... uptime clock is running

(follow-up: ↓ 4 ) 07/01/09 10:37:25 changed by owagner

The device in question has:

bootnv_ver=6, pmon_ver=CFE 4.175.64.12

(in reply to: ↑ 3 ) 07/01/09 11:33:11 changed by davel

Replying to owagner:

The device in question has: bootnv_ver=6, pmon_ver=CFE 4.175.64.12

My nvram reports bootnv_ver=7, pmon_ver=CFE 4.175.64.16

It did later lock up and and during restart ;

enable WRT610N phy reset hack

Unable to handle kernel paging request at virtual address 0000ff10, epc == 801b3614, ra == 801b35a0

Oops in fault.c::do_page_fault, line 206:

Had to catch it at boot and erase nvram. I failed to do a 3x30 reset.. lets see how it does factory config.

07/01/09 14:17:09 changed by Eko

  • status changed from new to closed.
  • resolution set to fixed.

Seems fixed with r12427